|
1992 Ford Mustang GT Sticking - Ignition System
Question: my starter was continuing to run for about two seconds after the car starts. i have replaced the starter four times, and put shims in between the starter and taken them out again. the problem started when i replaced the starter relay. now i am not sure i have all the wires in the right place on the realy. Can you help?
Here's How To Get Guaranteed Solutions In Minutes
|
|
Technican: Hi;
Allthe wires coming to it should go on the hotside ( battery side ) other then the only one thst goes to the stsrter and it will connect on the other side of the relay. The small push in wire connects to the little screw marked starter.
Owner: i have tried putting everything on the positive terminal except the ground wire, it is just clicking when i go to start it. all the lights and bells are working, just not starting...
Technican: Hi;
Your small wire should go to the front terminal. Make sure it is on there. Also you can take a screwdriver and by pass it and it should start. If it's a manual transmission make sure your safety neutral switch at the pedal is properly adjusted. Thanks. Here's How To Get Guaranteed Solutions In Minutes
|
|
|
